DESCRIPTION JOBO

1. In Auto Mode the motor starts whenever the water level in overhead tank is less than 25% and stops when the overhead tank is full.
2. In Manual Mode the device works only as a Water Level Indicator.
3. The Motor ON indicator lights up while the motor is running.
4. The Top-Up Switch is meant for semi automatic operation i.e manual ON auto OFF. Motor turns On when this switch is pressed and will automatically turn OFF once the tank is full. This switch works only in Auto Mode.
5. The Power ON indicator indicates whether device is ON or OFF.
6. Remove the connector cover to make sensor and supply connections

INSTALLATION JOBO

1. Measure the depth of the water tank by inserting the yellow sensor in it.
2. Mark the depth of tank on yellow wire with a black tape.
3. Now join the Green sensor at 25% level, Blue sensor at 50% level, Red sensor at 75% level and black at 100% level (below the black tape) using small wire ties provided in the box.
4. Now clip the extra part of wire ties and put this arrangement in the tank. To give proper support to this bundle of wires, tie it to a nearby pipeline using bigger wire ties.
5. Extend these sensor wires using 0.5mm electrical wire or a 5 core wire (Both are easily available at any electrical shop).
6. Now Mount the device on the wall.
7. Remove the Connector cover and make the connections as described in installation circuit.
8. Screw the connector cover back to the device.